14-Inch Double-Sided Hoof Rasps by Working Width

The flat 14-inch double-sided rasp lists a 350 mm body length, two body widths of 45 and 50 mm and 4.8 mm thickness. Both widths appear with chopped and milled tooth options. If you want a fitted rubber grip, compare the 14-inch carbon steel model or a KD939A double-sided rasp. Confirm active tooth width and grip before choosing a bulk configuration.

Full flat catalogue hoof rasp diagonally positioned on a finely textured charcoal rubber bench mat

The Two Listed 14-Inch Widths

Both body widths in the flat alloy-steel listing share the same nominal length and listed thickness. The usable width of the teeth is a separate sample measurement.

Flat 14-inch catalogue optionDimensions from the listingFace and order check
45 mm body350 × 45 × 4.8 mmSelect chopped or milled if relevant and record tooth width
50 mm body350 × 50 × 4.8 mmVerify the extra 5 mm in body width at the same measuring point
Rubber-handled carbon steel option14 in nominal, two faces and silver selectionConfirm working width and fitted length for this model
Rubber-grip KD939ACatalogue also lists a 16 in sizeWrite 14 in on the order line if that is the intended version

The Coarse Face and the Finishing Face

Check both sides of the same sample. The coarse side is listed for shaping and the finer side for finishing. The working area and tooth texture of each side tell you more about the configuration than the phrase double-sided alone.

Photographic macro of the two real hoof rasp face textures

A 5 mm Width Difference You Can Check

Moving from a listed 45 mm to a listed 50 mm body adds 5 mm of body width. The actual contact patch depends on where the teeth start and end across the face. Compare the same cross-section on the test tools and record how much working width you can use.

Body width
Read at one agreed cross-section
Tooth field
Measure the active strip across both faces
Grip clearance
Confirm the hand or holder clears the blade shoulders

A Rubber Grip for the Ready-Handled Line

Compare the 14-inch carbon steel rasp with rubber handle and the rubber-grip double-sided rasp. Each catalogue listing is a separate candidate. Measure and request the width and grip of the particular model you want to buy.

Full-size carbon steel hoof rasp with its dark rubber grip resting across a pale grey field mat

The Reorder Line for the Approved Width

A useful line on the quote reads 14 in nominal, 50 mm listed body width, exact face options and grip arrangement. The current flat model lists polished and coated finish options and an HRC 55–62 range. Carry only the relevant confirmed selections and any material evidence into your purchase specification.

Body
Length, width and thickness
Faces
Coarse and fine functions, with the selected tooth option
Order proof
Revision, grip, finish and sample reference

A Sample Check for a Team or Distributor

Ask the team to compare both working faces and the grip on each option. Record the conditions and assign an internal label to the approved configuration. The resulting record is useful if another buyer places the next order.

Face
Measure the toothed area on both sides
Grip
Compare clearance and balance
Reorder
Keep the same approved model and width

A Profile Reference for Working Face Measurements

Ask for a reference drawing or a measured sample if width, thickness or the shoulder matter to you. Keep the reading tied to both the model and the point it was taken from. Our batch quality guide shows where to save it.

Close-up side view of the shoulder and toothed area of a true-profile handled hoof rasp alongside a plain metal straightedge

A Path to Longer or More Aggressive Tools

Move to a length comparison if what you need is a longer toothed reach. Move to a coarse sample comparison if the main difference is cutting feel on your typical work.

A 14-Inch Sample Request by Width

Send the width, working face, grip and estimated quantity your order needs. We can discuss which named configurations to sample and price.