Hoof Rasp Lengths for Mobile Kits and Long Working Faces

Compare the tool you can use and store rather than ordering by the inch label alone. Our flat 9-inch configuration lists 225 mm body length. The 16-inch coarse stainless rasp and 18-inch stainless finishing rasp are longer nominal candidates. Ask for the active length and the assembled length on each model.

Long handled hoof rasp positioned lengthwise on an uncluttered charcoal farrier bench

Nominal Lengths in the Current Range

A catalogue designation identifies the model. Carry these actual measurements separately before assigning a kit or shelf position.

Listed modelCatalogue length informationUseful check
Short flat double-sided model9 in and 225 mm in the dimensional tableMeasure the active coarse and fine lengths for a kit
Straight KD939A14 and 16 in listed on the same productWrite the ordered length explicitly and check its fitted grip
Coarse stainless rasp16 in nominalRecord coarse face reach and the assembled length
Stainless finishing model18 in nominal, black or silver selectorsRequest a measured tooth field and finish choice

A 9-Inch Option for a Mobile Kit

The 9-inch row for the flat double-sided model lists 225 mm. Check how the tool sits in your case and whether the grip, if supplied, changes storage length. Allow room to access the tool and protect both working faces.

One short-looking flat bare hoof rasp safely fitted in a shallow canvas farrier tool roll

Three Measurements for a Tool Roll

Measure the beginning and end of the teeth on each side. Measure the whole tool separately with the intended grip attached. A 225 mm catalogue body can occupy a different amount of room when its grip is installed, so your usable tool-roll pocket needs its own reading.

A
Nominal or listed body length
B
Active toothed length on side one and side two
C
End-to-end dimension with the chosen grip

A 16-Inch Option with a Coarse Face

Our 16-inch coarse stainless steel rasp gives you one long double-sided candidate. The straight 14- and 16-inch model gives you another choice to compare. Look at tooth placement and access around the shoulder alongside the nominal length.

Close low-angle view of the long coarse toothed field and shoulder of a sixteen-inch catalogue hoof rasp on a textured green worktop

The 18-Inch Shortlist

The two 18-inch listings have overlapping uses but they keep separate order references. The leveling and finishing listing and the shaping and smoothing listing both show black and silver choices. Compare the cut and active face length on the exact SKU to select a functional difference using the actual differences in cut or contact.

Longer contact
Confirm toothed reach on both faces
Tool handling
Confirm overall length, handle and working clearance

A Tool Roll and Work Space Check

Measure the usable inside length of the case and record the place where the tool is held. Compare it with the handle, where applicable, and with the amount of working face you can use in the intended space.

Storage
Internal length and protection
Working area
Clearance and active tooth area
Handling
Grip and balance in your usual setup

Putting the Long Tool on a Measured Bench

A straight-on reference photo with clear endpoints shows what a label leaves open. Ask for a measured sample or photo showing both sides and the grip if the 18-inch option is under consideration.

Straight long stainless hoof rasp positioned alongside a plain straight metal ruler with markings deliberately out of focus

Length and Shape in the Same Purchase

Once the working length is clear, use the standard 14-inch width guide or compare curved tools for local contact. Those comparisons let you select the next tool without losing the measurements you already have.

An Order Specification Based on Reach

Send your target toothed length, case dimensions or hand clearance, and the quantities you plan to buy. We can review length and grip options by model.