Two-Hole File Holders for Flat Body Files

The two-hole aluminium file holder is listed for compatible flat body files used in bodywork and aluminium surface finishing. The centre spacing is an order measurement to confirm. Send the centre-to-centre distance, hole specification and file body section so the holder can be checked on the exact order.

Two-hole aluminium body-file holder on a cool graphite worktop

The Three Interfaces That Decide Holder Fit

You can define the quote with a marked image or a simple drawing in millimetres. Each field should identify where it is measured on the real tool.

Fit fieldWhat to supplyAcceptance check
Hole locationsTwo centre points, their spacing and any offset from the edgeLine up centres on the body file and support
Holes and fastenersDiameter, hole type and intended fastenerConfirm clearance and that the fasteners match the support
Flat-body sectionWidth, thickness and seating surface near both holesCheck that the mounted file has full support and sits without unwanted rocking
PackageHolder on its own or separate fasteners and body fileState each part and quantity on its own line

Mounting Details in a Close View

A close view of the two holes and the support surface helps you identify the layout. Include the flat body file you need to match, with mounting points and any clearance limits clearly visible.

Low close-up of the actual aluminium holder near one mounting contact point

A Two-Hole Drawing with Measured Centres

Mark each centre and the side of the file that seats against the holder. If you measure from edge to edge, include the method and the hole diameters so the centre distance can be checked. Show any countersunk side and which fastener is intended.

P
Centre-to-centre distance between holes
D
Diameter and shape of each hole
B
Body width and thickness at the seats

A Flat-Body Profile for the Fit Review

Our holder is listed for compatible flat body files used in body or aluminium surface finishing. Share the profile at the mounting region and any mark or revision that identifies it. Keep the assembled trial separate from a product photograph.

Aluminium file holder resting above a separate generic flat-body file blank on a pale industrial bench

A Sample Assembly Record

Check alignment and contact on the actual model. Record which fastener and blade were used in the trial and whether the fitted parts sit securely against the support surface.

File reference
Model, drawing and physical sample
Holder reference
Model and confirmed mounting dimensions
Hardware
Fasteners, thread and supplied pieces
Acceptance
Alignment, support and approved assembly

A Fit Check Before a Replacement Purchase

A trial assembly should identify the tool file, the holder and the fasteners before it is accepted. Photograph the support and the two fitted locations. Keep the approved pairing in the order record if shops will reorder mounts for several different flat file models.

Measure
Send the key dimensions
Match
Review actual sample and fasteners
Confirm
Document the supported pairing

Receiving the Holder and Hardware

Specify whether you need the holder by itself or the matching fasteners and file included on separate order lines. Check what arrives against the written configuration before you record the approved assembly for your team.

Aluminium two-hole file holder and a small blank hardware tray on a charcoal-brown dispatch worktop

Related Accessory Orders by Interface

Replace a tang-mounted handle using tang and socket measurements. Order a separate cleaning brush by bristle type and compatibility with your file.

A Holder Quote with a Measured Fit

Submit the two hole centres, diameter and file width and thickness. Include the extra parts you want quoted with the holder.